Table of Content Content 1. Product Introduction 2. Transmitter ID to Receiver by LF005 3. Limit Warranty 3.1 Warranty Service 3.2 What Are Not Covered 4. Thing to Notice 5.
1 Product Introduction LF005 is a controller, used to transmit transmitter ID saved in ID-Transcorder to Receiver. Transmitters sometimes are used to Trailer, but drays of trailers are usually exchanged to another trailer. It means transmitter ID is not fixed. For this kind of situation, we need ID-Transcorder recording transmitter ID and LF005 transmitting ID to Receiver. Take the models of TX008 RX004, and DS002 to help explain how to use LF005 completely.
2 Transmitter ID to Receiver by LF005 Antenna POWER CABLE 1. Take RX004 for example. Check receiver is on power and antenna is connected. 2. Turn on the LF005. On / Off Switch 3. Take LF005 close to DS002 in 20~30 centimeters and push the button. 20~30 centimeters 4. Check RX004 show ” Tx’s ID OK ”,and push any button to return normal display model. If it shows ” Tx’s ID LOST ”, please try again. NOTE The value above is for reference.
3.
3.2 This Limited Warranty Provided by Mobiletron Does Not Cover (1) Product that have been subjected to abuse, accident, alteration, modification, tampering, negligence, misuse, faulty installation, lack of reasonable care, improper transportation, repair or service in any way that is not authorized by Mobiletron. (2) Any damage attributable to fire, flood, lightning strike or act of God. (3) This limited warranty coverage will exclude the package material and user manual.
5. Technical Specifications 5.1 Operation Condition $ ! " # ! # ! ' % & 5.2 Radio Transmitter ( ) * $ - ! " +% , $ & ! ( 5.3 General Specification ! ! . / "0 ". / 0 ! "/ . " 3 1 2 5.
FCC Caution: 1.The device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 2.This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. 3.
