BAT-X (BASIC ASSET TRACKER, ATD500X) USER GUIDE V5.0.
BAT-X 1 CONTENTS 2 Introduction ....................................................................................................................................................................................... 3 3 Firmware ............................................................................................................................................................................................ 3 3.1 4 5 6 Firmware Versions ......................................................
BAT-X 2 INTRODUCTION This document describes the Mobilogix BAT-X (Basic Asset Tracker, ATD500X). BAT-X is an asset tracker equipped with LTE CatM1/NB1, quad-band 2G, Bluetooth, GNSS, environmental, and IMU sensors. The BAT-X may be in one of three operating modes. Factory mode is set on BAT-X during production for initial delivery and long-term storage of BAT-X. In Factory mode no radios are on, BAT-X waits for 10 minutes of charging to switch to Normal Mode.
BAT-X 5 5.1 OPERATING MODES NORMAL MODE Normal Mode will allow BAT-X to go between sleeping and active work states to report data to the cloud. Active work states are triggered by hold-off timers and threshold values according to the BAT-X configuration.
BAT-X 5.2 DISCOVERY MODE Discovery Mode is an ultra-low-power mode where BAT-X acts as a Bluetooth beacon. Since no tracking is possible in Discovery Mode it can be used to conserve battery during periods of inactivity. Entry Triggers: • Normal Mode to Discovery Mode: REST API Exit Triggers: • Discovery Mode to Normal Mode: Write operation via Bluetooth Available Functions: • • BT OTA BT Advertising Radio Modes: • • 5.
BAT-X 6 6.1 6.2 HARDWARE SENSORS Type Units Minimum Maximum Temperature Celsius (° C) -20 60 Pressure Hectopascals (hPa) 300 1100 Humidity % Relative Humidity (%RH) 0 100 Light Lux (lx) 0 64000 Shock Magnitude G Forces 1 25.5 Shock X-axis G Forces 1 25.5 Shock Y-axis G Forces 1 25.5 Shock Z-axis G Forces 1 25.
BAT-X 6.4 RADIOS Cellular Module: Bluetooth Module: Antenna: Quectel® BG96 (Qualcomm® MDM9206) Silabs® BG13P Embedded Cellular/GPS/Bluetooth/WiFi (rx) Radio Frequencies: LTE-FDD B1 LTE-FDD B2 LTE-FDD B3 LTE-FDD B4 LTE-FDD B5 LTE-FDD B8 LTE-FDD B12 LTE-FDD B13 LTE-FDD B18 LTE-FDD B19 LTE-FDD B20 LTE-FDD B28 LTE-TDD B39 850 (B5) 900 (B8) 1800 (B3) 1900 (B2) GPS Bluetooth WiFi TX (MHz) 1920 ~ 1850 ~ 1710 ~ 1710 ~ 824 ~ 880 ~ 699 ~ 777 ~ 815 ~ 830 ~ 832 ~ 703 ~ 2570 ~ 824.2 ~ 880.2 ~ 1710.2 ~ 1850.
BAT-X 7 CONTACTS • • 8 8.1 support@mobilogix.com https://mobilogix.com/contact/ DISCLAIMERS FCC INTERFERENCE STATEMENT (PART 15.105 (B)) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
BAT-X 8.4 ISED RSS-GEN NOTICE This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.