User's Guide


11
Range:180secondsto15,552,000seconds.  Recommendednotsettingtovalueslongerthan24hoursor86400seconds.  The
commSynchPeriodshouldnotbeprogrammedtobelessthanthemonitorPeriodandshouldnotbeprogrammedtobemorethan12xthe
monitorPeriod
3.3.3 opMode
TheopModeisusedtocommandthedeviceintoSetupMode.  
Values:1:KeepdeviceinActiveoperation.  0:PlacedeviceintoSetupMode
3.3.4 reportBuffReset
ThereportBuffResetisusedtocommandthedeviceresetits‘history’bufferofsensorreportscollectedwhilethedevicehasbeenofflinefrom
thenetwork.  
Values:1:Resetthehistorybuffer.
3.3.5 alarms
Pleaserefertothedatamodeltoconfigbelowalarms:
lowBatt:lowbatteryalarm
tempAlarm:temperatureoverflow/underflowalarm
humiAlarm:humidityoverflow/underflowalarm
liteAlarm:liteoverflow/underflowalarm
owtAlarm:onewiretemperatureoverflow/underflowalarm
shockAlarm:shockalarm
tiltAlarm:tiltalarm
reportType:motion‐basedperiodicreportingenable/disable
owtDisc:plugoutonewiresensor 