User's Manual

7. SAR

This device complies with part 15 of the FCC Rules.

Operation is subject to the condition that this device does

not cause harmful interference.

FCC ID: 2ADA4F1035D

Any changes or modifications not expressly approved by

the party responsible for compliance could void the user's

authority to operate the equipment.

NOTE: This equipment has been tested and found to

comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful

interference in a residential installation. This equipment

generates uses and can radiate radio frequency energy

and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio

communications. However, there is no guarantee that

interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio

or television reception, which can be determined by

turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the

following measures:

---Reorient or relocate the receiving antenna.

---Increase the separation between the equipment and

receiver.

---Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

---Consult the dealer or an experienced radio/TV

technician for help.

Body-worn Operation

This device was tested for typical body-worn operations.

To comply With RF exposure requirements, a minimum