User Card

The HiRes Video Company
US
www.mobotix.com
HiRes Video Innovations
The German company MOBOTIX AG is known as the leading pioneer in network camera technology and its
decentralized concept has made high-resolution video systems cost-ecient.
MOBOTIX CORP • Manhattan (NY) • Phone: 888-MOBOTIX (662 6849) • [e-mail] • Made in Germany
BellRFID: Regulatory Notice
Federal Communications Commission (FCC) and Industry Canada (IC)
Notice for MX-Bell1-Core (M/N: Bell-A)
(FCC ID: YYRBELLA, IC ID: 9357A-BELLA)
NOTICE:
This device complies with Part 15 of the FCC Rules [and with ICES-003 of Industry Canada]. Operation is subject
to the following two conditions:
(1) this device may not cause harmful interference, and
(2)
this device must accept any interference received, including interference that may cause undesired operation.
NOTICE:
Le présent appareil est conforme aux CNR d‘Industrie Canada applicables aux appareils radio exempts de
licence. L‘exploitation est autorisée aux deux conditions suivantes:
(3) l‘appareil ne doit pas produire de brouillage, et
(4) l‘utilisateur de l‘appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d‘en compromettre le fonctionnement.
NOTICE:
Changes or modifications made to this equipment not expressly approved by MOBOTIX AG may void the FCC
authorization to operate this equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Radiofrequency Radiation Exposure Information:
The radiated output power of the device is far below the FCC radio frequency exposure limits. Nevertheless,
the device shall be used in such a manner that the potential for human contact during normal operation is
minimized.
Ministry of Internal Aairs and Communications Notice for
MX-Bell1-Core
NOTICE:
• This device has been granted a designation number by Ministry of Internal Aairs and Communications
• This device should not be modified (otherwise the granted designation number will be invalid)
IP Video Door Station
MX-Bell1-Core
31.579_US_V1_07/2013
MOBOTIX BellRFID
MX-Bell1-Core
(in IP Video Door Station
triple frame white)
RFID cards
for keyless entry
(1 admin card, 5 user cards)
Available Bell Button Sets
(Accessory)
The Jones
Family
The Jones
Family
Dr. Jones, MD
Cindy Jones
Thomas Jones
Dr. Jones, MD
Cindy Jones
Thomas Jones
The Jones Family
Dr. Jones, MD
Bell Button Module
with RFID Technology
for up to Five Parties
Cindy Jones
Thomas Jones
The Jones Family
Dr. Jones, MD
Caroline Jones
Cindy Jones
Thomas Jones
The Jones Family
Dr. Jones, MD
The Jones
Family
Cindy Jones
Thomas Jones
The Jones Family
Dr. Jones, MD
Weatherproof (IP65)
–30 to +60°C/–22 to +140°F