User manual

1.6.3 Starting the Camera Using the Factory IP Address
If the camera's IP address is not known, you can start the camera with its factory IP
address. Section 3.6,
Starting the Camera Using the Factory IP Address , describes
this procedure in more detail.
1.6.4 Resetting the Camera to Factory Defaults
All settings of the MOBOTIX camera can be reset permanently to the factory default
settings. This makes sense if you have, for example, obtained a camera without
any information or you would like to reset all settings after testing the camera. In
order to perform this procedure, you need to have access to the administration
area of the camera (admins group). Open Admin Menu> Reset … to reset the
camera to factory defaults.
Note: All defined users will be deleted and the admin password will be reset to
the factory default when you reset the camera using Admin Menu> Reset …
Proceed according to section 3.6,
Starting the Camera Using the Factory IP
Address
, if you would like to maintain existing users.
1.6.5 Activating Event Control for Security Applications
In its default configuration, the camera's event control and video motion detec-
tion features are not enabled. In order to activate event control as a whole, open
Setup Menu> General Event Settings and activate the Arming switch. Click on the
Arm& Record softbutton of the user interface in the browser to enable the stan-
dard event features. The video motion detection window is visible in the live image
(dotted frame in the center) and the camera automatically stores images as soon
as the video motion window detects movements.
1.6.6 Deactivating Text and Logo Options
As the camera arming has been deactivated in its default configuration (see prece
ding section), the MOBOTIX camera only displays the Text WWW.MOBOTIX.COM,
the time stamp and the MOBOTIX logo at the top of the image. Once the camera
arming has been activated (see section1.7.5), the text at the bottom of the live
image (event, action and messaging symbols) will also appear.
You can deactivate the status text at the bottom and the text at the top left corner of
the live image by setting Text Display in the Setup Menu> Text & Display Settings
dialog to
Off . Setting Text Display to Date & Time will only display the time stamp in
the live image.
In order to hide the logo in the live image, open Admin Menu> Logo Profiles and
set Logo Display to
Disable .
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
21/100
D22 Camera Manual Part 1
The configuration can also
be reset partially
If the dotted rectangle in
the live image is visible,
the camera is armed
Text and logos can be also
deactivated or customized
to your liking