User manual

2.6 Mounting the D22 to a Ceiling Using the On-Wall Set
Before mounting the MOBOTIX D22-IT/Secure to an indoor or outdoor location
using the On-Wall Set, you need to prepare the network connection and drill the
holes for the fixtures:
• Network connection: You can use any one of the four openings in the On-
Wall mount to guide the cabling into the camera. When using the On-Wall
Set, you cannot mount the camera directly on top of the wall outlet (regard-
less whether it's a flush-mounted outlet or an above-the-wall model).
When preparing the installation, you should make sure that the cable is at
least 15cm (6in) long within the housing of the On-Wall Set (excluding the
connector itself). This will ensure that you can turn the lens unit freely later on.
Cable that is too long can be stored easily within the On-Wall mount.
• Drilling the holes: Prepare the holes in the ceiling. Make sure that you have
the supplied dowels ready for this purpose. Use the supplied drilling tem-
plate for the D22 On-Wall Set (fold-out at the end of this manual) to mark the
position for drilling the dowel holes and the holes through which the cables
will be led later on.
Procedure
• Apply a sufficient amount of silicone around
the holes at the back of the housing to pre-
vent water from entering. When doing so,
make sure that you do not block or seal
off the condensation vent!
• Use the delivered screws to mount the On-
Wall Set (without the camera) to the ceiling.
• If the cables are guided through one of the
openings in the On"Wall Set, insert the cables
into the On"Wall mount.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
56/100
D22 Camera Manual Part 1
Find the folded drilling
template of the D22 On-
Wall Set at the end of
the manual!
Seal off the holes at
the back of the housing
using silicone sealant!
Do not seal off the con-
densation vent!
Maximum torque for all
screws is 1 to 1.2Nm
(0.74lbf ft)
Caution
Note that the On-Wall Set can also be used in outdoor applica-
tions (IP65). When doing so, make sure that you seal off the holes
at the back of the housing using good-quality silicone sealant.
Note
When mounting the MOBOTIX D22 to a wall, you should always use
the D22 wall mount instead of the On-Wall Set.
Do not seal
off vent!