User manual

2.8 Mounting the D22 Vandalism Set
In order to install the Vandalism Set, replace the regular outer shell and the Allen
screws with the stainless steel shell, the security screws and the four spacers of the
Vandalism Set. Likewise, replace the dome of the D22-IT/Secure with the reinforced
dome of the Vandalism Set.
• Remove the outer shell. Remove all four Al-
len screws using the supplied Allen wrench.
Take off the outer shell.
• Remove the camera dome. Remove the
dome of the D22-IT/Secure (by turning it in
counter-clockwise direction), then package
and store the dome.
• If required, clean the lens gently using a lint-free cotton cloth. Do not apply
excessive pressure onto the glass surface when cleaning the lens! Make
sure that you do not change the lens focus or the lens unit when doing so.
You should once again control the sharpness of the camera images on a
computer monitor (see section 2.5.3).
• Mount the reinforced dome of the Vandal-
ism Set. Use a soft cotton cloth and mount
the reinforced dome by placing the dome into
its seat and turning it in clockwise direction. If
required, clean the dome gently using a lint-
free cotton cloth before installing it. You
should once again control the sharpness of
the camera images on a computer monitor
(see section 2.5.3).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
60/100
D22 Camera Manual Part 1