User manual

2.9 Mounting the D22 to a Wall Using the Wall Mount

Before mounting the MOBOTIX D22-IT/Secure with the Wall Mount you need to

prepare the network connection and drill the holes for the fixtures:

• Network connection: The network cabling is supplied through the opening in

the back of the wall mount. The cabling is perfectly protected by the mount

and cannot be seen or damaged. The wall mount can be mounted directly

on top of wall outlets (flush-mounted or above-the-wall types; maximum di-

mensions of the outlet: 88x 80mm (3.5x 3.2in) width x height).

Use the factory pre-installed network cable of the D22 (50cm (20in) length).

This will ensure that you can turn the lens unit of the D22 freely later on.

• Drilling the holes: Prepare the holes in the wall. Make sure that you have the

supplied dowels ready for this purpose. Use the supplied drilling template for

the D22 Wall Mount (fold-out at the end of this manual) to mark the position

for drilling the dowel holes and the holes through which the cables will be

led later on.

Procedure

• Disengage the mounting ring from the

housing of the D22-IT/Secure. This ring is not

required when mounting the camera to the

Wall Mount.

• Use the delivered screws to mount the Wall

Mount (without the camera) to the wall (di-

rectly on top of the cabling or the wall outlet).

www.mobotix.com • sales@mobotix.com

62/100

D22 Camera Manual Part 1

Maximum torque for all

screws is 1 to 1.2Nm

(0.74lbf ft)

Caution

Only use the factory pre-installed network cable of the MOBOTIX

camera. It is very important that the rubber plug of the network

cable reliably protects the housing from moisture entering the

camera. All openings of the camera housing need to be closed off

properly. This will ensure that the camera remains weatherproof.