User manual

3.2 Overview of the Configuration Settings
Once the connection has been established, you can configure the camera by click-
ing on the Admin Menu button or the Setup Menu button.
Using the Quick Installation wizard
After first booting the camera or after resetting it to factory defaults, any access to
the administration menu (Admin Menu button) will start the Quick Installation.
The wizard will guide you through the most important settings of the camera (confi-
guration of the network interface, image control, etc.) and can also be used to reset
the camera to its factory settings.
It is also recommended to use Admin Menu> Quick Installation later on as well,
e.g. if you would like to change connection parameters or add a new connection
type.
Administration and setup of the camera
Basic configuration tasks of the camera (e.g. passwords, interfaces, software up-
dates) are carried out from the administration menu (Admin Menu button), which
requires the corresponding access rights (
admins group, user name and pass-
word).
Open the Setup Menu (button) and find the dialogs for changing the image, event
and recording settings in the Image Control and Event Control sections. These op-
tions are also available for users belonging to the
users group. Some of these set-
tings can be changed using the corresponding pull-down menus above the image
on the Live screen.
The image settings are already optimized
The factory image settings of MOBOTIX cameras deliver excellent images for most
application scenarios and should not be changed. If you do wish to make changes,
your changes should be minor and gradual.
If you would like to reset changes without resetting the complete configuration to
factory defaults, you can use the Factory button at the bottom of the dialog to reset
only this dialog's settings. If you would like to reset all image settings, you may do
so using the Manage Settings> Restore Image Settings pull-down menu above
the image on the Live screen.
All changes are temporary
All changes to the configuration are only temporary and can thus be tested easily.
Restoring the previous configuration settings can be achieved using the Restore
button in most dialogs or by running Admin Menu> Restore last stored configu-
ration from flash (see also section 5.9,
Managing Settings , in the Software Man-
ual
).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
72/100
D22M Camera Manual Part 1
Always use Quick Instal-
lation for initial configu-
ration!
Admin Menu
User: admin
Password: meinsm
Setup Menu
Recommendation: Always
use factory image set-
tings!