User manual

96/148
D24M Camera Manual: INSTALLATION
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
2.13.4 Power Supply When Connected Directly To A Computer
1. Connect the factory pre-installed cable of the camera to the Camera connector of
the Network Power Adapter.
2. Connect the PC/Power connector of the Network Power Adapter to the Ethernet
port of the computer.
3. Plug the RJ45 connector of the external power unit into the LAN/Power connector
of the Network Power Adapter.
2.13.5 Power Supply (PoE IEEE 802.3af) Using Power-over-Ethernet Products
Connect the factory pre-installed cable of the camera to the Ethernet connector of the PoE
switch/router. The switch/router must support the PoE standard IEEE 802.3af.
For the D24M, you
should use the new
blue MX-NPA-PoE-Set
- previous MOBOTIX
network power acces-
sories such as the NPA
Set, Power Box and
Power Rack (MX-NPA-
Set, MX-NPR-4 and
MX-NPR8/20) are
not suitable for use
with the D24M
The IP addresses in
the diagram are shown
only as an example
The IP addresses in
the diagram are shown
only as an example