User manual

Mx2wire+ User Manual: INTRODUCTION
© MOBOTIX AG • Security Vision Systems • Made in Germany
www.mobotix.com • [e-mail]
16/44
Overview: Maximum power levels for Mx2wire+
(power supplied via: PoE+, IEEE 802.3at)
Antenna or Coaxial Cable
Thickness
Length of coaxial cable
50 m 100 m 500 m
0.6mm
inner core
Data: 50Mbps
Power: 13W
Data: 50Mbps
Power: 11W
Data: 45Mbps
Power: none
Telephone Line and Bell Wire
Thickness
Length of telephone line/bell wire
50 m 100 m 200 m
0.6 mm Data: 50Mbps
Power: 13W
Data: 50Mbps
Power: 13W
Data: 50Mbps
Power: 8W
0.8 mm Data: 50Mbps
Power: 13W
Data: 50Mbps
Power: 13W
Data: 50Mbps
Power: 13W
Installation Cable
Thickness
Length of installation cable
50 m 100 m 200 m
1.5 mm
2
Data: 50Mbps
Power: 13W
Data: 50Mbps
Power: 13W
Data: 50Mbps
Power: 13W
Extending The Range With Network Installation Cables
Mx2wire+ can also be used to extend the range of an Ethernet connection that is limited
to just 100m in length (between the PoE switch and end device). For this purpose, a Cat7
installation cable is converted to a two-wire cable as follows: Open the four twisted wire
pairs and remove approx. 7mm of insulation from the ends. Then connect the four white
wires and the four colored wires to one cable respectively and attach wire-end sleeves.
Open the four
twisted wire pairs
Remove
insulation from the
ends of all eight wires
Combine 4x white
and 4x colored
Use two wire-end sleeves
to connect to the two
Mx2wire+ connectors