User manual

Mx2wire+ User Manual: INSTALLATION
© MOBOTIX AG • Security Vision Systems • Made in Germany
www.mobotix.com • [e-mail]
22/44
2.3 Mounting Instructions
Please check that all components supplied with Mx2wire+ are present in the original
packaging (see Section 2.1). In order to avoid damaging the device, you should always use
the assembly parts provided. In addition to the Mx2wire+ media converter, the following
tools are required for installation:
• Philips screw driver
• Power drill for screw anchor holes (drill size: 5)
• Hole saw (68mm) for supplied cavity socket
• MOBOTIX drilling template (at the end of this manual)
• Scissors to cut out the drilling template
• Pen to mark the drill holes
• Tools for preparing the two-wire cable (such as a cable stripper)
• Screwdriver for cable anchors on the housing (such as a voltage tester)
Solid Concrete Or Stone Wall, Minimum Thickness: 60 mm
Use a in-wall socket and, if required, the supplied screw anchors und Torx screws for
the installation.
Cavity Wall (e.g., Plasterboard, 7 mm to 35 mm)
Use the supplied cavity socket for the installation.
Note
In principle, an Mx2wire+ unit can be installed using the on-wall socket, a standard
in-wall socket or a cavity socket (see Sections 2.4 to 2.6).
Cavity socket (wood or
plasterboard, for example)
Standard
in-wall socket
On-wall socket
Never connect
or handle live cables
(e.g., 230 V power supply)
on your own; always have
a trained electrician
do the installation