User manual

Mx2wire+ User Manual: INSTALLATION
© MOBOTIX AG • Security Vision Systems • Made in Germany
www.mobotix.com • [e-mail]
24/44
Preparing the Standard In-Wall Socket
In general, the existing in-wall socket of the two-wire cable continues to be used for
Mx2wire+. Otherwise, an in-wall socket must be fitted first. Make sure that the socket you
use is as flush with the wall as possible, so that you can install the respective Mx2wire+ unit
properly. Make sure that the socket and Mx2wire+ unit are aligned correctly in the wall.
After connecting the two-wire cable, there are two ways to attach the Mx2wire+ circuit
board to the in-wall socket:
1. Secure the Mx2wire+ housing and circuit board directly to the socket by fastening
two small screws (item 1.4) in the 12 o'clock and 6 o'clock positions. However, this
requires that the socket is properly aligned in the wall. Thanks to the elongated
shape of the screw holes, it is possible to make small adjustments to the left and to
the right when tightening the screws.
2. Use four or two (diagonally opposite one another) Torx screws/screw anchors
(item 1.6) to tightly screw the Mx2wire+ housing and circuit board to the wall. We
recommend this procedure if the installed in-wall socket is not properly aligned
or is not flush with the wall. Otherwise, the Mx2wire+ unit could easily be pulled
out together with the in-wall socket.
Two screws, diagonally opposite one another, are normally sucient.
Caution
Do not drill through live cables in the wall.
Attached to the socket
using two screws
(item 1.4)
Attached to the wall
using two or four 4 Torx
screws/screw anchors
(item 1.6)