User manual

Mx2wire+ User Manual: INSTALLATION
© MOBOTIX AG • Security Vision Systems • Made in Germany
www.mobotix.com • [e-mail]
28/44
2.6 Installation Using Cavity or In-Wall Socket
1. Prepare the cavity or in-wall socket: see Section 2.4
2. Two-wire cable to screw terminals 1 and 2: It is
important that one cable is attached to the terminal
with the same number on both Mx2wire+ units.
The device can overheat if terminals 1 and 2 are
swapped.
3. Outputs of power supply unit to screw terminals
3 and 4: If, instead of a PoE switch/injector, a DC
power supply unit (48–57V) is used to supply power,
it is connected to one of the two Mx2wire+ units.
See the description for alternative connection options
in Section 3.2.
4. Remove the front panel and frame*: In order to protect
the Mx2wire+ circuit board, it is attached to the front
panel and frame in the original packaging. In order
to continue with the installation, however, you must
first separate the housing and circuit board (item 1.1)
from the panel and frame. Loosen the screw in the
front panel (item 1.2) and lift the panel forwards.
Now remove the attached frame from the circuit board.
Please note that you will need the stainless steel screw
in the front panel again later.
4 3 2 1
Connectors 1 and 2
cannot be swapped
(danger of overheating)
The screw does not need
to be removed completely
from the front panel
* If not already done
(see Section 2.5)