User manual

© MOBOTIX AG • Security Vision Systems • Made in Germany
www.mobotix.com • [e-mail]
29/44
5. Insert the housing and circuit board into the socket:
The two cable clamps on the rear of the housing are
located at the top. When using a cavity socket (item
1.9), make sure you only use the stainless steel screws
provided (item 1.6). Other (larger) screws could damage
the circuit board.
6. Attach the frame: Place the selected frame (item 1.3,
concave, convex or flat) onto the circuit board and
press down gently until it automatically snaps into
place. MOBOTIX is printed on the bottom of the frame.
7.
Insert the panel: Hook the front panel onto the frame,
as shown in the figure, and then press it down.
8. Screw the panel on tightly: Secure the front panel
using the panel's stainless steel screw. Continue with
Section 3 (Operation).
The circuit board
is attached directly
to the socket using
two screws (item 1.4.)
(see left) or it is
attached to the wall
using the Torx screws
(see page 24)
First hook panel on underneath,
then click closed above
MOBOTIX printed
at the bottom