User manual

Mx2wire+ User Manual: INSTALLATION
© MOBOTIX AG • Security Vision Systems • Made in Germany
www.mobotix.com • [e-mail]
30/44
2.7 Installation With On-Wall Socket
1. Prepare the on-wall socket: Use the supplied drilling
template for the on-wall socket (fold-out at the end of
this manual) to mark the precise position of the drill
holes and the cable guide. Make sure that the alignment
and position of the socket in relation to the two-wire
cable are correct (TOP/ OBEN arrow) .
2. Feed in the cables and screw on the on-wall socket:
Feed the two-wire cable and the power supply unit
(if used) through the opening provided that is sealed
with a rubber plug. Use the 8-wire plug for the individual
wires. The other plugs with only one opening are
ideally suited to insulated, multi-wire cables of varying
thickness. Now use the four Torx screws (item 1.6) to
securely fasten the on-wall socket to the screw anchors
or directly to the (wooden) surface. Please ensure that you only use the existing
four drill holes of the on-wall socket .
3. Remove the front panel and frame*: In order to protect
the Mx2wire+ circuit board, it is attached to the front
panel and frame in the original packaging. In order
to continue with the installation, however, you must
first separate the housing and circuit board (item 1.1)
from the panel and frame. Loosen the screw in the
front panel (item 1.2) and lift the panel forwards
Now remove the attached frame from the circuit board.
Please note that you will need the stainless steel screw
in the front panel again later.
Supplied cable plugs
For cables of 3–5 mm
For cables of 5–7 mm
For cables with a
maximum of eight wires
The screw does not need
to be removed completely
from the front panel
* If not already done
(see Section 2.5)