User manual

www.mobotix.com • sales@mobotix.com

31/44

4. Two-wire cable to screw terminals 1 and 2: It is

important that one cable is attached to the terminal

with the same number on both Mx2wire+ units.

The device can overheat if terminals 1 and 2 are

swapped.

5. Outputs of power supply unit to screw terminals

3 and 4: If, instead of a PoE switch/injector, a DC

power supply unit (48–57V) is used to supply power,

it is connected to one of the two Mx2wire+ units.

See the description for alternative connection

options in Section 3.2.

Insert the housing and circuit board into the on-wall

socket: The two cable clamps on the rear of the housing

are located at the top. Attach the housing and circuit

board to the on-wall socket by fastening the four

stainless steel screws (item 1.4) in the four existing

drill holes.

7. Attach the frame: Place the selected frame (item 1.3,

concave, convex or ﬂat) onto the circuit board and

press down gently until it automatically snaps into

place. MOBOTIX is printed on the bottom of the frame.

Insert the panel: Hook the front panel onto the frame,

as shown in the ﬁgure, and then press it down.

9. Screw the panel on tightly: Secure the front panel

using the panel's stainless steel screw. Continue with

Section 3 (Operation).

Connectors 1 and 2

cannot be swapped

(danger of overheating)

4 3 2 1

First hook panel on underneath,

then click closed above