User manual

© MOBOTIX AG • Security Vision Systems • Made in Germany
www.mobotix.com • [e-mail]
39/44
2. Both Mx2wire+ units receive sucient power from the PoE switch (green LEDs). A
data connection from the end device (PC) to the PoE switch is established (orange
LEDs), however, no data is currently being transferred.
3. The blinking of the orange LEDs on both units indicates that data is being
transferred from the camera to the switch via Mx2wire+.
4. When the green LED on the sender lights up rather than blinks, this indicates that
no PoE-supplied end device is in operation here.
Overview: Error Messages 1 To 3
LED 1 – Sender LED 2 – Sender LED 1 – Receiver LED 2 – Receiver
1 ON ON ON OFF
2 ON ON OFF OFF
3 OFF OFF OFF OFF
1. Sender receives sucient power from the PoE switch. A data connection to the
PoE switch is established via Ethernet. Although sucient power is being sup-
plied to the receiver, no connection to the end device is established.
Troubleshooting tip: Either the network cable between the receiver and the end
device is not functioning properly (cable is defective or too long) or there is a
problem with the end device.
2. Sender receives sucient power from the PoE switch. A data connection to the
PoE switch is established via Ethernet. Receiver is not functioning, as it is not re-
ceiving any power and can therefore not establish a connection to the end device.
Troubleshooting tip: Either the two-wire connection is not functioning properly
(interrupted or too long) or there is a problem with the receiver.
3. The sender itself does not receive any power from the switch and no data con-
nection is established. This means that the receiver cannot function either.
Troubleshooting tip: Either the network cable between the sender and the switch
is not functioning properly (cable is defective or too long) or there is a problem
with the switch (either not suitable for Mx2wire+ or faulty) or with the sender.