User manual
2.4 Mounting the Camera Without Additional Mounting Options
1) Prepare the network connection: The network cabling is supplied from di-
rectly behind the camera in the center of the housing. The cabling is perfectly
protected and cannot be seen or damaged.
2) Drill the holes: Drill the holes for the supplied dowels. Use the supplied drill-
ing template for the camera mounting ring (fold-out at the end of this man-
ual) to mark the position for drilling the dowel holes and the holes through
which the cables will be led later on.
3) Remove the outer shell: Remove all four Al-
len screws using the supplied Allen wrench.
Take off the outer shell.
4) Connect the cable: Connect the network ca-
ble to the network cable of the camera using
a patch cable connector.
5) Mount the camera with the mounting ring:
Use the delivered screws to affix the mount-
ing ring and the camera at the designated
position. Make sure that the OBEN/ TOP ar-
row points into the desired direction.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
50/112
Q22M Camera Manual Part 1
Find the folded drilling
template for the mounting
ring of the camera at the
end of the manual!
Maximum torque for all
screws is 1 to 1.2Nm
(0.74lbf ft)
Note
Use a flush-mounted (empty) wall outlet for the network cabling. The
camera itself cannot be mounted directly on top of protruding wall out-
lets.