User manual

2.5 Mounting With the On-Wall Set
1) Prepare the network connection: You can use any one of the four openings
in the On-Wall set to guide the cabling into the camera. When using the On-
Wall set, you cannot mount it directly on top of a protruding wall outlet.
2) Drill the holes: Drill the holes for the supplied dowels. Use the supplied drill-
ing template for the On-Wall set (fold-out at the end of this manual) to mark
the position for drilling the dowel holes and the holes through which the ca-
bles will be led later on.
3) Apply silicone: Before mounting the set, apply
some silicone around each hole to prevent wa-
ter from entering the housing. Make sure that
the back of the pressure equalization ele-
ment is not sealed off by silicone!
4) Mount the On-Wall set: Use the delivered screws to mount the On-Wall set
(without the camera) at the designated position.
5) Prepare the cabling: Guide the cable into the inside of the On-Wall set.
6) Remove the outer shell: Remove all four Al-
len screws using the supplied Allen wrench.
Take off the outer shell.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
52/112
Q22M Camera Manual Part 1
Find the folded drilling
template of the On-Wall
set at the end of the man-
ual!
Seal off the holes at
the back of the camera
with silicone!
Keep the pressure
equalization element
open!!
Maximum torque for all
screws is 1 to 1.2Nm
(0.74lbf ft)
Caution
Note that the On-Wall set can also be used in outdoor scenarios
when mounted to a ceiling (IP65). Make sure that the holes at the
back of the housing are sealed off using silicone.
Note
When mounting the MOBOTIX Q22M to a wall, you should always use
the Wall Mount instead of the On-Wall set.
Do not
close off!