User manual

2.8 Mounting to a Wall Using the Wall Mount
1) Prepare the network connection: The network cabling is supplied through
the opening in the back of the wall mount. The cabling is perfectly protected
and cannot be seen or damaged. The Wall Mount can be mounted directly
on top of wall outlets (flush-mounted or above-the-wall types; maximum di-
mensions of the outlet 88x 80mm (3.5x 3.2in) width x height).
2) Drill the holes: Drill the holes for the supplied dowels. Use the supplied drill-
ing template for the Wall Mount (fold-out at the end of this manual) to mark
the position for drilling the dowel holes and the holes through which the ca-
bles will be led later on.
3) Remove the outer shell: Remove all four Al-
len screws using the supplied Allen wrench.
Take off the outer shell.
4) Remove the mounting ring: Disengage the
mounting ring from the housing of the cam-
era. This ring is not required when mounting
the camera to the Wall Mount.
5) Mount the Wall Mount (without camera):
Use the delivered screws to mount the Wall
Mount (without the camera) at the designated
position.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
58/112
Q22M Camera Manual Part 1
Find the folded drilling
template for the Wall
Mount of the camera at
the end of the manual!
Maximum torque for
these screws is 4Nm
(2.95lbf ft)
Caution
Only use the factory pre-installed network cable of the MOBOTIX
camera. It is very important that the rubber plug of the network
cable reliably protects the back of the housing from moisture en-
tering the camera. All openings at the back of the camera housing
except the pressure equalization element need to be sealed off
properly. This will ensure that the camera remains weatherproof.