Specifications

63/1�61�6
Mounting The Camera Without Accessories
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
Mount the camera:6. Use the (included) screws to affix
the mounting ring and the camera at the designated
position.
Install the rubber seal:7. Place the rubber seal with the
groove around the edge of the black mounting ring of
the camera.
Attach the outer shell: 8. Re pl ace the o ute r s he ll and s cr ew
all four Allen screws tight using the supplied Allen wrench.
Ensure that the rubber seal is properly positioned.
Clean the lens9. : If necessary, gently clean the front of
the lens with a soft cotton cloth. Do not apply excessive pressure to the surface of
the glass when cleaning the lens.
Establish a connection to the camera, check the image10. : Establish a connection
to the camera as described in sections 3.1 ff. The live image from the camera
should be visible on the computer monitor. Check image sections on the computer
monitor as well.
Caution
The maximum torque for all screws is 1 to 1.2 Nm.
Only use the factory pre-installed network cable supplied with the MOBOTIX camera.
Always ensure that the cable retainer with bayonet catch is closed properly around
the network cable. All openings at the back of the camera housing except the pres-
sure equalization element need to be sealed properly with the rubber plugs. This is
the only way to guarantee that the camera remains weatherproof.