Technical data

83/148
Before Mounting
© MOBOTIX AG • Security Vision Systems • Made in Germany
www.mobotix.com • [e-mail]
• Pencil to mark the drill holes
•
Potentially LSA+ tool for fitting an installation cable onto the LSA terminals of the camera
• Hole saw or Forstner drill with 44 to 45mm/1.77in diameter for the S14D sensor
modules or with 35mm/1.38in diameter for the S14M lens
• Soft cotton cloth to clean the front of the lens after installation
2.2.11 Preparatory Steps
Make sure of the following before starting to install the camera:
•
Connection with MOBOTIX patch cable : The network connector has been guided
either with an MX-Patch-Box, an MX-NPA-Box or a standard network port (only
permitted in indoor areas) into the vicinity of the mounting position of the camera.
•
Connection with installation cable : If a network installation cable is used instead, it
may not conduct any voltage and may not be connected to the network.
•
Even surface : Make sure before attaching the camera that the surface is even so
that the base plate of the camera does not move.
•
Pressure equalization element : This element on the housing of the S14 and the
sensor modules must be kept free to enable pressure equalization element of the
camera housing.
S14D/S14M
FlexMount (front)
Sensor module (rear)
Do not cover pressure
equalization elements