Technical data

87/148
Installing The S14D FlexMount
© MOBOTIX AG • Security Vision Systems • Made in Germany
www.mobotix.com • [e-mail]
3. Turn the extension in a clockwise direction until it clicks
into place (viewed from the right). The extension will
lock automatically and will not turn, even if the nuts
are loosened.
Note
Make sure that the extensions are always connected as described in Step 2. Attaching
the extensions incorrectly will damage the bayonet catch and may result in the nuts
not being properly attached.
Removing Extensions
Proceed as follows to loosen and undo an extension lock:
1. Push the extension towards the sensor module to
unlock it.
2.
Turn the extension in an anti-clockwise direction (viewed
from the back) to open the bayonet catch.
3. Remove the extension.
2.3.4 Connecting Network Cables And Additional S14D Cables
Once you have mounted the S14D and the sensor modules you can connect the network
cables of the camera, a MiniUSB cable, if required, and additional cables (MxBus, microphone,
speaker) as described in Section 2.5, «Network And Power Connection, Additional Cables» .
1
2
3