User manual

3.3.6 Starting the Camera Using the Factory IP Address
Under certain circumstances, you may have to reset the camera to its factory IP
address. This could be the case if the IP address of the camera has been lost or the
camera does not react to the last known IP address.
Proceed as follows to start the camera using its factory IP address:
• Remove the outer shell using the supplied
custom tool (see section 2.14,
Dismantling the
Camera
).
• If the camera is powered on, disconnect the
power supply of the camera by unplugging
the corresponding cable.
• Reconnect the power supply of the camera.
• Wait until all LEDs are lighting up simultane-
ously.
• Now hold the magnetic side of the custom tool onto the spot above the
microphone labeled L in the figure (the switch is inside the camera housing).
• Only release the custom tool when the camera plays a single sound
(“Boing”).
The camera is now accessible again using its factory IP address (see label on
the camera housing).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
107/132
D12 Camera Manual Part 1
Passwords and camera
settings will not be
changed!
Make sure you store the
factory network configu-
ration to the permanent
flash memory!
Users and passwords will
not be changed!
Note
If you use the camera's "L" key to load the factory network configura-
tion, this configuration is not automatically saved to flash memory.
Upon restarting the camera the next time without using the camera's
"L" key, the
last stored network configuration will be used. To perma-
nently store the new network configuration in the camera's flash mem-
ory, open Admin Menu> Store ...
Caution
As opposed to resetting the camera using Admin Menu> Reset
configuration to factory defaults
, the user information will not be
reset if the camera is booted using the factory IP address.
Microphone
"L" key