User manual

Use the supplied drilling template (fold-out at the end of this manual) to mark the

position for drilling the dowel holes and the holes through which the cables will be

led later on. When printing or copying the drilling template, make sure that it is not

scaled down!

• Use the supplied 10mm dowels (item4.3),

8x70mm screws (item4.5) and 9mm dia.

washers (item4.4) for mounting the Out-

door Wall Mount to the wall!

• Before mounting the wall mount, attach the

supplied wall sealing (item4.6) to its rear

(wall) side using some silicone sealant. If the

outdoor wall mount is mounted to a very

rough surface, the top of the wall mount

should also be sealed against the wall using

good-quality silicone sealant.

• The rectangular opening at the wall mount's

rear side is supposed to cover the wall outlet.

• If you

do not

use the pre-installed Ethernet

cable, make sure that the cable runs at

least 70cm (28in) from the wall or wall out-

let (80cm (32in) when using the Corner and

Pole Mount, see section 2.11).

www.mobotix.com • sales@mobotix.com

62/132

D12 Camera Manual Part 1

Find the folded drilling

templates at the end of

the manual!

Make sure that the drill-

ing template is not scaled

down when printing!

Silicone sealant is

optional!

Cable length from wall:

minimum 70cm (28in)

Cable length from wall:

min. 80cm (32in) when

using the Corner and Pole

Mount

70cm/28in