User manual

2.15.3 Mounting to a Concrete or Brick Wall

Use the supplied materials and suitable tools for mounting the camera to a concre-

te or brick wall. Follow the

Mounting Instructions

below to complete the installation.

Required Materials:

• 3 hex head screws (itemM.3)

• 3 washers (itemM.2)

• 3 dowels (itemM.1)

Required Tools:

• Power drill

• Suitable drill bit

• Wrench or ratchet for M6 hex heads

• Hammer (optional)

• Allen wrench 5mm (item1.11)

Mounting Instructions:

• Hold the drilling template at the position where you would like to mount the

camera.

• Mark the holes for drilling with a pencil or a sharp object, then remove the

drilling template.

• Drill the holes with the power drill where you just marked.

• Insert a dowel (itemM.1) into each of the holes you just drilled. If required,

use the hammer to press the dowels into the holes.

• Slide a washer (itemM.2) over every hex head screw (itemM.3).

• Hold the camera against the wall. Make sure that the openings in the

mount's foot line up with the dowels.

• Insert the four screws (with washers) into the openings in the foot of the cam-

era and into the dowels.

• Tighten the screws using the wrench or ratchet (max. torque is 4Nm/

2.95lbfft).

www.mobotix.com • sales@mobotix.com

77/132

D12 Camera Manual Part 1

Caution: The screws

should be at least 15mm

(5/8in) longer than the

dowels

Find the drilling template

at the end of the manual

Max. torque for all

screws: 4Nm

(2.95lbf ft)