User manual

Once a connection has been established, click on the Admin Menu button to start

configuring the camera. The Admin Menu controls all network settings (IP address,

netmask, DHCP, etc.), ISDN behavior and all other options.

The configuration follows these steps:

1) Establish the first connection (Ethernet or ISDN).

2) Set the parameters for the desired connection type (Ethernet/ISDN) using the

Quick Installation wizard.

3) Set the event control (events, actions and messages); see chapter 7,

Events,

Actions and Messages

, in the

Software Manual

4) Set the storage target (internal storage, FTP, file server or Flash device).

5) Store the configuration in the camera's permanent storage (flash).

www.mobotix.com • sales@mobotix.com

85/132

D12 Camera Manual Part 1

Always use Quick Instal-

lation for initial configu-

ration!

Live image: http://preparkcam.mobotixserver.de

Note

After first booting a new MOBOTIX camera or after resetting to factory

defaults, accessing the Administration menu (Admin Menu button) will

automatically start the Quick Installation wizard. This is where you

configure the most important camera parameters in a step-by-step

manner. If you have completed the Quick Installation wizard at least

once, the standard Administration menu will open when you click on

the Admin Menu button.