Co. Ltd. Modem User Manual

CiM-550 IP Enabled Satellite Modem Rev. 2
SNMP interface CD/CIM550.IOM
253
13.5.1.7 STATUS PARAMETERS
Table 13-42. Status Parameter OIDs
OID
Description
cim550RxEbno
Value of Ebi/No, can be between 0 and 160 in 0.1 dB
where 0 = 0.0 dB to 160 = 16.0 dB and 999 = Demod
Unlocked
cim550RxCoarseAGC
Vaue of Coarse AGC setting, can be between 0 and 99.
cim550RxFrequencyOffset
Value of frequency offset of the carrier being
demodulated.
Can be between -30 KHz and 30 KHz
where -30 = -30 KHz to 30=+30 KHz and 999 = Demod
Unlock.
cim550BufferFillState
Value of the buffer fill state. Can be between 0 and 99 in
percentage filled.
cim550RxBER
Value of the estimated corrected bit error rate. Value has
been
multiplied by 10E
-10
.
cim550RedundancyState
Returns the redundancy state of the unit, where: 0 = Off
Line (forced into standby by 1:N or 1:1 Switch) 1= On
Line (normal). Valid values are:
0 Offline
1 Online
cim550ModemUnitFaults
Returns the current fault and status codes for the Unit
(hardware). The value will be a integer between 0 and
8191 where the bit that is set indicates which fault has
occurred:
bit 0 not used, always 0
bit 1 volt power supply
bit 2 12 volt power supply
bit 3 5 volt power supply
bit 4 18 volt power supply
bit 5 12 volt power supply
bit 6 RAM load fail
bit 7 Tx synthesizer unlocked
bit 8 Rx synthesizer unlocked
bit 9 Power cal checksum fail
bit 10 FPGA main chain load fail
bit 11 Turbo FPGA load fail
bit 12 IP Module fail