Installation Guide

6
Step Two
 Make sure the area to be drilled does not have any hidden electrical wires or water and gas
pipes.
 The wall fixings provided is for concrete walls only; please use suitable fixings for your wall type.
If in doubt, contact a qualified hardware expert.
 Place the three bulged screw tubes into the drilled holes and then screw in the self-tapping
screws. Screw the extended wooden screws into the 0.20” screw anchors so they protrude out
of the wall to angle the fireplace. Make sure that the screws are secured in place.
 Have 2 people lift the fireplace and hook it onto the mounted bracket.
 Check the fireplace for stability to see if it is securely mounted.
Instructions for Use
This fireplace can be operated either by the switches located on the right side panel of the
fireplace or the supplied remote control.