Installation Guide

Power Switch

 Plug the fireplace into a power outlet. The fireplace is now in Standby mode.



Press the button once to turn on the fireplace and flame effect. An indicator light will light up

to indicate that the function is on. This will also turn on the flame effect.



Press the button once to turn off the flame effect. This will put the fireplace back into

Standby mode.

Heat Control

 Press the “Heat Control” button once for the low heat setting. Ten seconds later, the fireplace

will begin to dispense warm air (750W).

 Press the “Heat Control” button again to have the fireplace dispense hot air (1500W).



Press the “Heat Control” button again, and after ten seconds the heat will turn off.

Simulate Flames

 Press either the 〝+〞or 〝-〞button to brighten or dim the flames.

Timer

 Press the “Timer” button to set the fireplace to turn off after certain duration of time. Timer

duration ranges from 0.5hrs to 7.5hrs. The LED indicator lights up when the fireplace is in Timer

mode.

Note: All of the above functions can be operated by either the Control Panel or the Remote Control.

Remote Control

 The remote control requires 2 AAA batteries, which are not included.

 Point the remote control directly at the fireplace.

 The range is about 11.5 feet.

Troubleshooting

Problem Possible Solution

Unit does not work / does not heat

Check if the unit is plugged in the power outlet.

Check if the unit is in Standby mode. If so, turn

the unit ON.

· Check if the heat is turned OFF.

· Check for safety cut-off operation.

No flame effect

· Check if the unit is plugged in the power outlet.

· Check if the unit is in Standby mode. Turn the

unit ON.