Instructions / Assembly

3
ASSEMBLY
NOTE: It is best to use TWO PEOPLE for assembly of this gas fire pit.
1. Carefully unpack all items from the box. Place the base in the final position. There must be a minimum of 48 in
/ 122 cm of clearance from the side of the table top to any combustible walls.
2. Place the tabletop on the base. Secure the tabletop to the firepit base using the bolts and washers that are
provided
3. Pour the lava rock into the burner pan completely covering the burner.
4. Connect the hose and regulator to the cylinder. The propane gas and cylinder
are sold separately. Use a standard 20 lb / 9.1kg. propane cylinder only. Use this
fire pit only with a propane vapor withdrawal supply system. See Chapter 5 of the
standard for storage and handling of liquefied petroleum gas, ANSI/NFPA 58.
Your local library or fire department should have this book. Storage of an
appliance indoors is permissible only if the cylinder is disconnected and removed
from the appliance. A cylinder must be stored outdoors in a well-ventilated area
out of reach of children. A disconnected cylinder must have dust caps tightly
installed and must not be stored in a building, garage or any other enclosed area.
The maximum inlet gas supply pressure: 250 psi..
The minimum hourly of 50000 Btu is required input rating for a fire pit at rating less
than full input rating. The pressure regulator and hose assembly supplied with the appliance must be used.
1、F、H 未在图中显示
2、B、C 片标识反