User Manual

42 43

COBALT5S features two powerful stereo FX: Chorus and Delay.

Press the ‘FX’ switch once (so that the FX LED is statically illuminated) for the ADSR and Depth

controls to adjust the Chorus FX parameters. Press the ‘FX’ switch a second time (so that the

FX LED is ﬂashing) for the ADSR and Depth controls to adjust the Delay FX parameters. Press

the ‘FX’ switch again to return to the Chorus parameters.

Chorus

• A - Mod Depth: This parameter controls the depth of modulation for the Chorus.

• B - Mod Rate: This parameter controls the rate of modulation for the Chorus.

• C - Feedback: This parameter controls the amount of signal that is sent from the output

of the Chorus back into its input.

• D - Dry/Wet Mix: This parameter affects the Dry/Wet mix of the of the Delay engine’s

audio output with the pre-FX signal. When set to minimum, only the dry signal will be

heard. When set to maximum, only the FX engine’s signal will be heard.

Delay

• A - Delay Time: This parameter controls the interval of time between delay loops.

• B - Feedback: This parameter controls the amount of signal that is sent from the output

of the Delay back into its input.

• C - Filter: This parameter controls the cutoff for the built in ﬁlter.

• D - Dry/Wet Mix: This parameter affects the Dry/Wet mix of the of the Delay engine’s

audio output with the pre-FX signal. When set to minimum, only the dry signal will be

heard. When set to maximum, only the FX engine’s signal will be heard.

• Delay Type: This screen only parameter allows the delay to be conﬁgured as a ping/pong

or stereo delay

• Delay Sync: This parameter allows delay to follow the current synth tempo, this can be

accessed from the delay page on screen or turning the time encoder anti-clockwise past 0