Technical data

power add

ModelSim EE/SE Command Reference ModelSim Commands CR-111

power add

The power add command is used prior to the power report command (CR-112).

Data produced by these commands can be translated (by a Synopsys utility) to

drive the Synopsys power analysis tools. This command specifies the signals or

nets to track for power information. Returns nothing.

Syntax

power add

[-in] [-out] [-internal] [-internal] [-r] <signalsOrNets> ...

Arguments

-in

Select only inputs. Optional.

-out

Select only outputs. Optional.

-internal

Select only design internal signals or nets. Optional.

-ports

Select only design ports. Optional.

-r

Do the wildcard search recursively. Optional.

<signalsOrNets> ...

Specifies the signal or net to track. Required. Multiple names or wildcards may be

used. When using wildcards, switches filter the qualifying signals. The switches

select inputs, outputs, internal signals, or ports. If more than one switch is used,

the logical OR of the option is performed. This argument must refer to VHDL

signals of type bit, std_logic, or std_logic_vector, or to Verilog nets.