Instructions / Assembly

5/19

IMPORTANT SAFETY INFORMATION (continued)

• Before each use, remove the lava rocks. Examine the burner and its components. If dirty, clean

with a soft brush and soapy water solution. Examine the area around the burner; any dirt or

foreign material, such as spider webs or nests in this area should be removed. If it is evident that

the burner is damaged, the ﬁre table must not be used. The burner assembly cannot be replaced.

Please contact Elementi at 909-985-5553 for technical support.

• Place the hose out of the pathways where people might trip over it. Do not place the hose

in areas where it may be subjected to accidental damage.

! WARNING This outdoor ﬁre table is for use with liquid propane (LP) gas only. The

conversion to or attempted use of natural gas in this outdoorﬁre table is dangerous and

could result in serious personal injury, or property damage.

ATTENTION: Any alteration of the outdoorﬁre table that is not speciﬁcally directed in the

operations manual will void manufacturer warranty.

PROPANE (LP) DANGERS AND WARNINGS

LP Gas

• LP gas is flammable and hazardous if handled improperly. Become aware of the characteristics before

using any LP gas product.

Propane Characteristics

• Flammable, explosive under pressure, heavier than air and settles in pools in low areas.

• In its natural state, propane has no odor. For your safety, an odorant has been added.

• Contact with propane could burn your skin.

• Propane is extremely ﬂammable and hazardous if handled improperly.

LP GAS Warnings

• Cylinders must be stored outdoors in a well-ventilated area out of reach of children.

• Disconnected cylinders must have threaded valve plugs tightly installed and must not be stored

in a building, garage or any other enclosed area.

• Never use a propane cylinder with a damaged body, valve, collar or footing.

• Dented or rusted propane cylinders may be hazardous and should be checked by your propane

gas supplier.

• Be sure to use only one 20 lb (9.1 kg) LP gas cylinder with a Type 1 valve with this appliance as

required by the American National Standards Institute (ANSI) and the Canadian Standards

steering Committee. Only tanks marked “propane” may be used.

• The LP gas supply tank must be constructed and marked in accordance with the speciﬁcations

for LP gas tanks of the U.S. Department of Transportation (DOT) or the National Standard

of Canada, CAN/CSA-B339, LP gas tanks, Spheres and Tubes for the Transportation of

Dangerous Goods and Commission.

• LP gas tank must be arranged for vapor withdrawal.