User Manual

RADIO:
FM Band:
11
1. In standby mode, press the Button to power on the unit.
2. Press the FUNCTION Button repeatedly until “FM XX.X MHz” appear
on the display.
3. Turn the TUNING Knob to receive the desired FM station.
4. To read the actual time during listening, press the DISPLAY Button once.
Note: If the receiving FM station is stereo, the unit will auto plays it in
stereo mode.
AM Band:
1. In standby mode, press the Button to power on the unit.
2. Press the FUNCTION Button repeatedly until “AM XXX kHz” appear
on the display.
3. Turn the TUNING Knob to receive the desired AM station.
4. To read the actual time during listening, press the DISPLAY Button once.
Antennas:
AM:
This unit has a build in ferrite rod antenna, which provides adequate
reception in most areas. If reception is weak, reassemble the unit
to other location to improve reception.
FM:
The FM Antenna Wire on the rear of unit is for FM reception only. If
reception is weak, unwind it to full length and/or relocation.
AUX IN
Listen music from the external Audio Player as follows:
1. Connected the external Audio Player by an audio connection cable
with 3.5mm stereo plugs (Cable not included).
2. Insert one end to the AUX IN Jack on the front of unit.
3. Insert the other end to the Phones Jack; Line Out Jack or AUX Out
Jack on the external Audio Player.
4. Press the  Button to power on the unit from standby mode.
5. Press the FUNCTION Button repeatedly until indicator “AUX” appear
on the display.
6. Plays the music on the connected external Audio Player as usual.
Note: Make sure the volume level of the external Audio Player was set
to high. Otherwise, sound from this unit may weak.