User Manual

ALARM SET:

Important:

Shut off alarm:

1. In power off (Standby) mode. Press and hold the ALARM Button on the unit

or Remote Control approximate 2 seconds until indicator "TIMER" and alarm

display and the digit of hour of it is blinking.

2. Press the or Button on the unit or Remote Control repeatedly to set

the Hour of alarm. (Make sure the PM Indicator appear on the display if the

alarm time is PM and the AM Indicator is appear on the display if the alarm

time is AM).

3. Press the ALARM Button again, the digit of Minute will blink.

4. Press the or Buttons repeatedly to set minute.

5. Press the ALARM Button again, “Cd” will appear on the display.

Press the or Buttons repeatedly to select the weak up mode as desire as

below:

7. When finished setting, press ALARM Button again to save the settings and

exit. The actual time will appear on the display and the indicator “TIMER”

will stop blinking.

Cd= CD Mode

FM rd= FM Radio

AM rd= AM Radio

bu= Buzzer

If radio AM/FM was selected as the weak up mode, received the desired

radio station before activate alarm. Otherwise, when Alarm goes off,

no sound output from the speaker or sound weak.

If CD was selected as weak up mode, make sure you were place the CD

disc into the CD disc tray before activate alarm. Otherwise, when Alarm

goes off, no sound output from the speaker.

In power on mode, alarm will not functioning.

When alarm goes off, press the ALARM Button to turn off alarm, the

alarm will be reset for next day. (The indicator “TIMER” will keep in

display).

To turn off the alarm completely (not reset for next day). Press the

ALARM Button repeatedly until the indicator “TIMER” disappear on the

display.



time appear on the