User Manual

OPERATION

GENERAL OPERATION:

ACTUAL TIME SETTINGS:

1. Connected the unit to AC power as instructed earlier. The Red

Indicator will illuminate.

2. Press the Button on the unit or Remote Control to power on the

unit from standby mode. The Red Indicator will not light and the LCD

Display will illuminate.

3. Press the FUNCTION Button on the unit or Remote Control

repeatedly to select the playback source.

4. Press the VOL +/- Buttons on the unit or the VOL DN/UP Buttons on the

Remote Control to adjust volume level as desire.

5. When finished listening, press the Button on the unit or Remote

Control to turn off (standby) the unit. The Red Indicator will illuminate.

To set or reset the actual time:

1. In power off (Standby) mode. Press and hold the P-MODE/CLK SET

Button on the unit or Remote Control approximate 2 seconds until the

digit of Hour on the LCD Display is blinking.

2. Press the or Button on the unit or Remote Control repeatedly to

set hour. (Make sure the PM Indicator appear on the display if the

time is PM and the AM Indicator is appear on the display if the time is

AM).

3. Press the P-MODE/CLK SET Button again, the digit of Minute will

blink.

4. Press the or Button repeatedly to set minute.

5. When finished, press the P-MODE/CLK SET Button to save the

settings and exit. The display will stop blinking.

BT (BLUE TOOTH)

In first time use or re-pairing to a new BT Device, pairing it as below:

1. In standby mode, press the Button to power on the unit.

2. Press the FUNCTION Button repeatedly until the indicator

display and blink.

3. Power on the external BT Device and enter to BT searching mode. Start

pairing as the on screen instructions on the external BT Device. After

paired, the indicator will stop blinking. (For details pairing

procedures, please refer to the user’s manual of your BT Device.).

4. Plays the music in the paired BT Device as usual.

appear on the