User's Manual

E-1
CAUTION
Follow the advice below for safe operations.
z
Stop operation immediately if any liquid or solid object should fall into the cabinet.
z
If the unit is not to be used for a long period of time, make sure that all power
sources are disconnected
from the unit. Remove all batteries from the battery
compartment, and unplug the AC-DC adaptor from the wall outlet. Make it a
practice to remove the AC-DC adaptor by grasping the plug and not by pulling the
cord.
ON PLACEMENT
z
Do not use the unit in places, which are extremely hot, cold, dusty or humid.
z
Place the unit on a flat and even surface.
z
Do not restrict the airflow of the unit by placing it in a place with poor
ventilation, by covering it with a
cloth or by placing it on a carpet.
ON CONDENSATION
z
When left in a heated room where it is warm and damp, water droplets
or condensation may form inside
the unit.
z
When there is condensation inside the unit, the unit may not function normally.
z
Let it stands for 1 to 2 hours before turning the power on, or gradually heat the
room up and dry the unit
before use.
Should any trouble occur, remove the power source and refer servicing to qualified
personnel.
COMPLIANCE WITH FCC REGULATIONS
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
NOTE : This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.