Installation Guide

2/20/2018
1
Log Installation Step 1
Locate screws holding in the glass and remove
Log Installation Step 2
Carefully remove glass panel by pulling on the tabs located
on the left and right side of the firebox lean the glass
towards you and lift glass out. Make sure not to drag glass
as alignment pegs on bottom may damage module finish.
Log Installation Step 3
Open the Driftwood Log Set and locate the following:
Log set, Smoked Glacier Crystals, LED bulbs
Log Configurations:
LFV40/15 & LFV2-40/15: (1)-40” Log Set
LFV60/15 & LFV2-60/15: (1)-60” Log Set
LFV80/15 & LFV2-80/15 : (2)-40” Log Sets
LFV100/15 & LFV2- 100/15: (1)-40” Log Set & (1)-60” Log Set
LFV120/15 & LFV2-120/15: (2)-60” Log Sets
LOG SET
MEDIA LEDs
Log Installation Step 4
Locate and remove media tray strips.
Both the Clear strip and Colored strip.
LFV COLOR STRIP
LFV &LFV2 CLEAR STRIP
LFV2 COLOR STRIP
Log Installation Step 5
EXAMPLE OF LOCATION OF CONNECTORS FOR LOGS
(80” AND ABOVE WILL HAVE TWO CONNECTIONS)
Log Installation Step 6
After you locating the wires inside the fireplace and the
end of the driftwood logs. Plug in wires to each other.