Installation & Assembly

Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. DECEMBER 2017
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
ARGO
FM-4207, FM-4211, FM-4215
WARNING
IMPORTANT: NEVER attempt any work without shutting o the electricity.
- Read all instructions before installing.
- System is intended for installation by a qualied electrician in accordance with the National Electrical Code and local regulations.
- Go to the main fuse box, or circuit breaker. Place the main power switch in the “OFF” position and unscrew the fuse(s) or
switch ”OFF” the circuit breaker switch(es) that control the power to the xture or room that you are working on.
- Place the wall switch in the “OFF” position.
- Supply conductors (Power Wires) Connecting the xture must be rated minimum 90°C. If uncertain, consult an electrician.
CAUTIONS
- These luminaires (xtures) are designed to meet the latest NEC requirements and are listed in full compliance with UL 1598.
- Before attempting installation, check your local electrical code, as it sets the wiring standards for your locality.
Fig. 1
1.
Install the provided mounting plate to the junction box using
the junction box screws provided.
2. Provide electrical service according to the “National Electrical
Code” or your local electrical code to the outlet box.
4. Connect supply wires to fixture wires and insulate with
proper wire nuts:
Connect incoming ground wire to mounting plate ground wire
(green or bare).
Connect incoming common wire to xture common (white).
Connect incoming hot wire to xture black wire.
5.
Wire Connector
Qty: 3 pcs
P3
INCLUDED ACCESSORIES BAG
Junction Box Screw
Qty: 2 pcs
#8-32, * 3/4”
Stainless Steel
3", 4" or 3/0-4/0 electrical
box, (by others)
Fixture
INSTALLATION
Uses 3” junction box, 4" junction box or a combination
3/0-4/0 electrical box.
Wire Connector
3.
Clip the retention cable into the retention cable slot
on the mounting plate to assist with wiring.
Mounting Plate
Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Raise the fixture to mounting plate and guide the
metal clips through the openings in the
mounting plate until the fixture if flush with the
mounting surface.
6.
Rotate the fixture clockwise until fully tightened
with the mounting surface.
Junction Box
Mounting Screw
Retention Cable Slot