Installation Guide

ManualsBrandsModern Forms ManualsAll Modern FormsModern Forms Hand Held Remote Control for Modern Forms Ceiling Fans

OPERATION INSTRUCTIONS

SMART

F-RC-WT

Package Contents

Pairing

To pair your remote control:

1. Power cycle your fan by removing power from the circuit

breaker for 10 seconds and then re-enable power.

2. Press and hold and buttons on remote control

for 10-15 seconds.

3. The LED will blink green then remain solid green.

4. The green LED along with audible beeps will indicate

that pairing is successful.

5. Test remote control using the steps in section 2.

button: Switch between Summer and Winter Mode.

SUMMER MODE (Counter-Clockwise):

A downward airow creates a cooling

eect (FIG. 3). This allows you to set

your air conditioner on a warmer

setting without aecting your comfort.

WINTER MODE (Clockwise):

An upward airow moves

warm air o the ceiling area and

re-distributes the warm air that hovers

around the ceiling to the living space.

This should allow for savings on

heating costs (FIG. 4).

NOTE: To operate the reverse button on your fan,

press the button while the fan is running

Remote Control Operation

Remote Control Button Functions

button: Turns the light ON or OFF.

Press or hold to increase the light level.

Press or hold to decrease the light level.

button: Turns the fan ON or OFF.

Press or hold the button to increase fan speed.

Press or hold the button to decrease fan speed.

NOTE: Your fan features 6 speeds. An audible tone will indicate

when the speed is increased or decreased. When the fan has

reached the minimum/maximum speed level the audible

indication will stop.

BatteriesRemote Wall Cradle

Screws

CR2032

Unpairing

NOTE: Unpairing must be completed within 3 minutes

of turning the power on to the fan receiver.

1. When you re-engage power to the fans you

want to unpair, press and hold the and

buttons for 4 seconds.

2. The LED will alternate red/green, blink green, and the

receiver will beep to indicate that unpairing is successful.

Press and Hold

NOTE: A maximum of 2 fans can be operated using the

remote control.

FIG.1

FIG.2

FIG.3

FIG.4

FIG.5

Summary of content (2 pages)

PAGE 1
Pairing button: Switch between Summer and Winter Mode. To pair your remote control: 1. Power cycle your fan by removing power from the circuit breaker for 10 seconds and then re-enable power. 2. Press and hold and buttons on remote control for 10-15 seconds. 3. The LED will blink green then remain solid green. 4. The green LED along with audible beeps will indicate that pairing is successful. 5. Test remote control using the steps in section 2.
PAGE 2
4 Fan Wi-Fi Reset NOTE: This function only resets the Wi-Fi credentials. 1. Press and hold the and buttons for 6 sec. 2. The LED will light red, blink green and return to solid red, and the receiver will beep to indicate that Wi-Fi reset is successful. 3. After the Wi-Fi resets, the fan will broadcast its service set indicator (SSID). NOTE: If you are updating your router the fan will still appear in the Modern Forms app but will need to be re-paired.