Installation Guide

Fan Wi-Fi Reset
NOTE: This function only resets the Wi-Fi credentials.
1. Press and hold the and buttons for 6 sec.
2. The LED will light red, blink green and return to solid
red, and the receiver will beep to indicate that Wi-Fi
reset is successful.
3. After the Wi-Fi resets, the fan will broadcast its service
set indicator (SSID).
NOTE: If you are updating your router the fan will still
appear in the Modern Forms app but will need to be
re-paired. You can change the name of your fan on the
Modern Forms app upon re-pairing.
4
5
Factory Reset
NOTE: This will remove remote control and app connections.
Remote Control Factory Reset:
1. Press and hold the , and buttons
for 10 seconds.
2. The LED will blink red and return to solid red,
and the receiver will beep to indicate that the
factory reset is successful.
Receiver Button Factory Reset
1. Power down the receiver and within 3 minutes of turning
the power back on, press and hold the reset button on the
receiver until the receiver beeps.
2. Power cycle the circuit to complete the process.
NOTE: This will remove remote control and Modern Forms
app connections.
6
Modern Forms App
FIG.6
FIG.7
FIG.8
Press and Hold
CAUTION: The user is cautioned that changes or modications
not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment o and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
FCC Supplier’s Declaration of Conformity
Brand name: Modern Forms
Model number: F-RC-WT
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
WAC LIGHTING CO.
44 Harbor Park Drive, Port Washington, NY 11050
Tel: [phone]
Rules and Regulations