Installation Guide

FR-W1801

Wynd Instructions14

4. Assembling the Fan

CAUTION: Failure to properly install the cotter pin and/or tighten

the set screws could result in the fan loosening and possibly falling.

NOTE: Screws for Adapter plate (6) are preinstalled on the fan motor

assembly on the small ring at the center of the blades. Remove blue

packing ring if present.

1. Remove one screw from the inner ring on the motor assembly

and loosen the other 2 (Fig. 4).

2. Seat the Adapter Plate (6) on the center ring and twist to lock the

keyhole cutouts onto the screws previously loosened (Fig. 4A).

3. Replace the 3rd screw and tighten all 3 until snuggly secured by

hand.

NOTE: Screws for Luminaire Module plate (7) are preinstalled on the

Adapter Plate (6) on the middle ring. Luminaire Module itself comes

preinstalled on its mounting plate.

4. Remove one screw from the adapter plate for the luminaire

module and loosen the other 2.

5. Seat the Luminaire Module Plate on the adapter plate and twist

to lock the keyhole cutouts on the screws previously loosened

(Fig. 4B).

6. Replace the 3rd screw and tighten all 3 until snuggly secured by

hand.

7. Install glass shade without over-tightening or install metal light

cover (Fig. 4C).

NOTE: Add metal light cover if you do not need lighting function or

prefer a diﬀerent aesthetic.

NOTE: Do not connect the LED connector wires if you are using the

metal light cover.

NOTE: Do not overtighten screws or you may strip the screws or

damage the plating.