Installation Guide

FR-W1801
Wynd Instructions22
8. Finishing the Installation
1. Secure wire connectors with supplied wire ties.
2. Install canopy to mounting bracket with the screw
removed in section 2.
3. Install canopy screw ring as shown (Fig. 8).
7. Installing the Optional Wall Control
1. If replacing a pre-existing two switch setup, Modern forms wall
switches only require a hot, neutral, and ground to control both
the light and the fan. Use supply wires to provide the controller
its needed wiring, and choose either traveller wire previously
installed to bring power to the fan. Extra wires should be safely
and properly capped.
NOTE: Prexisting wiring may only provide power. Verify supply wiring
has a true neutral for operation.
NOTE: Traveller wiring to fan is strictly for power and allows for
emergency shut off via Modern Forms wall control. Signal is wireless
from wall control to receiver.