Installation Guide

10FR-W1802

6. HANGING THE FAN (cont.)

1. Slip the coupling cover, canopy screw cover (painted side face

down), and canopy (opened side up) onto the downrod. (Fig. 10).

Coupling cover goes all the way to the bottom.

2. Carefully reinstall the hanger ball onto the downrod, being sure

that the cross pin is in the correct position, the screw is tightened

and wires are not twisted. (Fig. 10)

3. Carefully lift the fan motor assembly up to the mounting bracket

and seat the hanger ball in the mounting bracket socket. Make

sure the tab on the mounting bracket socket is properly seated in

the groove in the hanger ball. (Fig. 11) Rotate the socket assembly

until the ball drops and locks into the hanger bracket screw.

4. Secure the safety cable to the building structure using a wood

screw (not included). (Fig. 11)

Motor wires

Canopy

Downrod

Coupling cover

Canopy screw cover

Safety cable

FIGURE 11

FIGURE 10

Wood Screw