Installation Guide

17FR-W1802
12. INSTALLING THE LED LUMINAIRE MODULE
WARNING: Before starting installation, disconnect the power by turning o
the circuit breaker or removing the fuse at fuse box.
1. Remove 1 of the 3 screws from the outer perimeter of the adapter plate
and keep it for future use. Loosen the other 2 screws (Do not remove).
2. Raise and hold the LED luminaire module close to the adapter plate and
proceed to secure the wire connections. Connect the white wire connec-
tors from the luminaire module to the white wire of the fan. Follow the
same procedure with the black wire connectors. (Fig. 19)
3. Tuck connections neatly into adapter plate. Place the luminaire module
key holes over the 2 screws previously loosened from the adapter plate.
Turn luminaire module until it locks in place at the narrow section of the
key holes. Secure by tightening the 2 screws previously loosened and the
one previously removed. (Fig. 19)
4. Raise acrylic shade up against the luminaire module, and secure it to
fan by turning acrylic shade clockwise until snug. Do not overtighten.
FIGURE 19
Adapter
plate
Connection plugs
LED Luminaire module
Screws
Glass
shade