Instructions / Assembly

FR-W1811
Aviator Instructions18
7. Finishing the Installation
1. Secure all wire connections with supplied wire ties to assist in
canopy installation.
2. Tuck connections neatly into ceiling outlet box.
3. Slide the canopy up to hanger bracket and place the key hole on
the canopy over the screw on the hanger bracket. Turn canopy
until it locks in place at the narrow section of the key holes (Fig. 7).
4. Align the circular hole on canopy with the remaining hole on the
hanger bracket. Secure by tightening the one screw previously
loosened and the one previously removed.
5. Adjust the canopy screws as necessary until the canopy and
canopy cover are snug.
WARNING: Make sure tab at bottom of hanger bracket is properly
seated in groove of hanger ball before attaching canopy to bracket.
Failure to properly seat tab in groove could cause damage to
electrical wiring.
1. Place fan blade on motor as shown (Fig. 5) and secure with the
blade attachment screws and washers.
2. Repeat this procedure with the remaining blades.
3. Secure the bottom of the fan blades together using the provided
blade collector ring and hardware (Fig. 5A).
1. Install the decorative lower cap adapter as shown (Fig. 5A).
2. Tightly twist the decorative lower cap onto the motor assembly
(Fig. 6).
5. Attaching the Fan Blades
6. Attaching Decorative Lower Cap