Troubleshooting Guide

18FR-W1812; FR-W1813
12. FINISHING THE INSTALLATION
1. Secure all wire connections with supplied wire ties to assist in cano-
py installation.
2. Tuck connections neatly into ceiling outlet box. Position the motor
up to the hanger plate and attach the motor using two screws
through the two key slots (Fig. 20).
3. Slide the canopy up to the hanger bracket and place the key hole on
the canopy over the screw on the hanger bracket. Turn canopy until
it locks in place at the narrow section of the key holes (Fig. 20).
4. Align the circular hole on canopy with the remaining hole on the
mounting bracket. Secure by tightening the one screw previously
loosened and the one screw previously removed.
5. Lock the canopy ring onto the screws in step 4. Adjust the screws as
necessary until the canopy and canopy ring are snug (Fig 18).
WARNING: Make sure the tab at the bottom of the hanger bracket is
properly seated in groove of hanger ball before attaching canopy to
bracket. Failure to properly seat tab in groove could cause damage to
electrical wiring.
FIGURE 20